What You Get With Your Purchase Of The Arizer Argo
- 1x Arizer ArGo
- 1x 18650 Battery
- 1x USB Charger
- 2x Borosilicate Glass Aroma Tubes
- 1x Belt-Clip Carry Case
- 2x Silicone Stem Caps
- 1x Steel Stirring Tool
- 4x Stainless Steel Screens
- 1x Instruction Manual
How The Argo Vaporizer Works
Simply load up the dry herb chamber with some coarsely ground dry herb then gently push and slightly twist the glass aroma tube into the container to fill the dish. When loading do not overpack or leave the herb too loose in the chamber.
Preheat the ArGo before inserting any tight tubes. To turn the ArGo on, press and hold the M and + button. The screen will illuminate and start counting down, continue holding the M and + buttons until the unit beeps and greets you with a smiley face. You will see the power delay time start to countdown. A beep is heard and a greeting is displayed when the ArGo is powered on. To set the temperature, press the + button and the device will start heating to the previously used temperature. Press the + or – buttons to adjust the temperature in 1° increments. Inhale vapor through the glass aroma tube with a slow steady draw. Try using different inhaling techniques with different temperatures to suit your personal needs and preferences.
Maintenance Of The Argo Travel Vaporizer
After numerous uses your Arizer ArGo should be cleaned to ensure optimal performance. If any materials fall into the heater bowl, simply turn the device upside down to empty the debris. Use the stainless steel cleaning tool to remove any materials from the borosilicate glass aroma tube. Soak glass components in isopropyl alcohol for a couple of hours then rinse with hot water. In most cases doing this will clean the glass tubes as good as new, but if not, simply repeat as necessary. Always ensure the glass aroma tubes are fully dry before your next use.